Torque Specifications

1996 Saturn SW2 L4-1.9L DOHC VIN 7SECTION Torque Specifications
Component Torque/lb ft

Air Box 7.4
Clutch Fork Stabilizer 18
Clutch Housing Dust Cover 7.4
Clutch Housing To Engine Bolt (Bottom) 103
Clutch Housing To Engine Stud (Top) 74
Clutch Hydraulic Damper Nuts 18
Converter Housing Ground Terminal 18
Cradle Bracket To Cradle 52
Cradle To Body 155
Down Pipe To Converter 33
Down Pipe To Exhaust Manifold 23
Down Pipe To Stiffening Bracket 23
Engine Mount To Cradle 66
Flex Tube [01] 18
Flywheel 59
Ground Terminals To Clutch Housing Studs (Top) 18
Ignition Module 5.1
Intermediate Shaft Support 40
Lower Ball Joint 55
Lower Converter Housing 96
Lower Transaxle Mount 52
Pressure Plate 18
Rear Transaxle Mount 52
Steering Gear To Cradle 40
Strut Cradle Bracket To Cradle 52
Tie Rod End 33
Transaxle Bracket To Transaxle 40
Transaxle Drain Plug [02] 40
Transaxle Stiffening Bracket 35
Transaxle Strut To Cradle 52
Transaxle Strut To Midrail Bracket 37
Transaxle Strut To Transaxle Bracket 52
Wheel Lug Nuts 103

[01] lb in
[02] Drain plug seal replacement is not necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.