Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1996SW2 L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISA L L DIAGNOSTIC TROUBLE CODES ( DTC )TESTING AND INSPECTIONDIAGNOSTIC TROUBLE CODE DESCRIPTIONSSIR - AIR BAG SYSTEMS
1996 Saturn SW2 L4-1.9L DOHC VIN 7
SIR - Air Bag Systems
1996 Saturn SW2 L4-1.9L DOHC VIN 7SECTION SIR - Air Bag Systems
DTC 15 - PASSENGER DEPLOYMENT LOOP RESISTANCE HIGH
DTC 16 - PASSENGER DEPLOYMENT LOOP RESISTANCE LOW
DTC 17 - PASSENGER DEPLOYMENT LOOP OPEN
DTC 18 - PASSENGER DEPLOYMENT LOOP SHORT TO GROUND
DTC 19 - PASSENGER DEPLOYMENT LOOP SHORT TO VOLTAGE
DTC 21 - DRIVER DEPLOYMENT LOOP RESISTANCE HIGH
DTC 22 - DRIVER DEPLOYMENT LOOP RESISTANCE LOW
DTC 24 - DRIVER DEPLOYMENT LOOP SHORT TO GROUND
DTC 25 - DRIVER DEPLOYMENT LOOP SHORT TO VOLTAGE
DTC 26 - DRIVER DEPLOYMENT LOOP OPEN
DTC 51 - DEPLOYMENT COMMANDED
DTC 53 - DEPLOYMENT COMMANDED WITH LOOP FAULTS PRESENT
DTC 61 - LAMP CIRCUIT FAILURE
DTC 71 - INTERNAL SDM FAULT
DTC 16 - PASSENGER DEPLOYMENT LOOP RESISTANCE LOW
DTC 17 - PASSENGER DEPLOYMENT LOOP OPEN
DTC 18 - PASSENGER DEPLOYMENT LOOP SHORT TO GROUND
DTC 19 - PASSENGER DEPLOYMENT LOOP SHORT TO VOLTAGE
DTC 21 - DRIVER DEPLOYMENT LOOP RESISTANCE HIGH
DTC 22 - DRIVER DEPLOYMENT LOOP RESISTANCE LOW
DTC 24 - DRIVER DEPLOYMENT LOOP SHORT TO GROUND
DTC 25 - DRIVER DEPLOYMENT LOOP SHORT TO VOLTAGE
DTC 26 - DRIVER DEPLOYMENT LOOP OPEN
DTC 51 - DEPLOYMENT COMMANDED
DTC 53 - DEPLOYMENT COMMANDED WITH LOOP FAULTS PRESENT
DTC 61 - LAMP CIRCUIT FAILURE
DTC 71 - INTERNAL SDM FAULT
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.