Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1993SC L4-1.9L SOHC VIN 9REPAIR AND DIAGNOSISTRANSMISSION AND DRIVETRAINAUTOMATIC TRANSMISSION/TRANSAXLETESTING AND INSPECTIONPROGRAMMING AND RELEARNINGTRANSMISSION LEARN-IN PROCEDURE
1993 Saturn SC L4-1.9L SOHC VIN 9
Transmission Learn-In Procedure
1993 Saturn SC L4-1.9L SOHC VIN 9SECTION Transmission Learn-In Procedure
If one of the repairs mentioned under Resetting Adaptive Parameters has been performed, then the adaptives should be reset using the Saturn Stall System.
The Saturn Stall System is used to set the adaptive parameters to a neutral value. Otherwise, additional road testing may be required to allow the PCM/TC to "learn" the new shift timing and points. Also, the vehicle must be driven, preferably on a highway, according to the following steps. By following these steps, the adaptives will be properly learned prior to returning the vehicle to the customer.
1. Place shift mode switch in the normal mode position.
2. Warm up transaxle (oil temp. above 45°C [113°F]).
3. Perform 10 sets of upshift (1-2, 2-3, 3-4) at 30% throttle:
4. While coasting at 64 km/h (40 mph) slowly accelerate to half throttle to achieve a 4-3 downshift.
5. With selector in D3 while coasting at 48 km/h (30 mph) slowly accelerate to one half throttle to achieve a 3-2 downshift.
6. Repeat steps 4 and 5 at least five times.
The Saturn Stall System is used to set the adaptive parameters to a neutral value. Otherwise, additional road testing may be required to allow the PCM/TC to "learn" the new shift timing and points. Also, the vehicle must be driven, preferably on a highway, according to the following steps. By following these steps, the adaptives will be properly learned prior to returning the vehicle to the customer.
1. Place shift mode switch in the normal mode position.
2. Warm up transaxle (oil temp. above 45°C [113°F]).
3. Perform 10 sets of upshift (1-2, 2-3, 3-4) at 30% throttle:
4. While coasting at 64 km/h (40 mph) slowly accelerate to half throttle to achieve a 4-3 downshift.
5. With selector in D3 while coasting at 48 km/h (30 mph) slowly accelerate to one half throttle to achieve a 3-2 downshift.
6. Repeat steps 4 and 5 at least five times.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.