Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1993SC L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISSPECIFICATIONSELECTRICAL SPECIFICATIONSIGNITION SYSTEMSYSTEM SPECIFICATIONS
1993 Saturn SC L4-1.9L DOHC VIN 7
System Specifications
1993 Saturn SC L4-1.9L DOHC VIN 7SECTION System Specifications
IGNITION COIL SECONDARY RESISTANCE
The measured resistance from tower to tower on the coils should be 7,000 Ohms to 10,000 Ohms.
CRANKSHAFT SENSOR RESISTANCE
The measures resistance of the crankshaft position sensor should be 700 Ohms to 900 Ohms.
SPARK PLUG WIRE RESISTANCES
The measures resistance of the spark plug wires should be below 12,000 Ohms.
The measured resistance from tower to tower on the coils should be 7,000 Ohms to 10,000 Ohms.
CRANKSHAFT SENSOR RESISTANCE
The measures resistance of the crankshaft position sensor should be 700 Ohms to 900 Ohms.
SPARK PLUG WIRE RESISTANCES
The measures resistance of the spark plug wires should be below 12,000 Ohms.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.