Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1992SL L4-1.9L SOHC VIN 9REPAIR AND DIAGNOSISSTEERING AND SUSPENSIONSTEERINGPOWER STEERINGPOWER STEERING PUMPSERVICE AND REPAIRREMOVAL/INSTALLATION
1992 Saturn SL L4-1.9L SOHC VIN 9
Removal/Installation
1992 Saturn SL L4-1.9L SOHC VIN 9SECTION Removal/Installation
Fig. 7 Belt Spring Tension Release:
1. Disconnect battery ground cable.
2. Remove power steering pump reservoir fill cap.
3. Raise and support vehicle.
4. Place suitable container below steering gear hoses.
5. Remove steering gear hoses and allow system to drain. Do not rotate steering wheel.
6. Using suitable box end wrench, relieve spring tension from accessory drive belt, then remove belt, Fig. 7.
7. On models equipped with DOHC, remove pump to intake manifold bracket, then pump to engine block bracket.
8. On all models, remove pump to engine block attaching bolts, then raise pump to disconnect EVO electrical connector.
9. Remove pump and hose assembly, then remove hoses.
10. Reverse procedure to install.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.