Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1992SL L4-1.9L SOHC VIN 9REPAIR AND DIAGNOSISBODY AND FRAMEDOORS, HOOD AND TRUNKDOORSFRONT DOORSERVICE AND REPAIRGLASS GUIDE REPLACEMENT
1992 Saturn SL L4-1.9L SOHC VIN 9
Glass Guide Replacement
1992 Saturn SL L4-1.9L SOHC VIN 9SECTION Glass Guide Replacement
GLASS GUIDE
REMOVAL
1. Remove outer door panel. Outer Door Skin Panel
2. Remove glass. (Refer to "Front Door Glass Replacement")
3. Remove window weatherstrip from guide.
4. Remove foam filler.
5. Remove attaching fasteners and glass guide.
INSTALLATION
1. Install glass guide loosely.
2. Install window weatherstrip.
3. Install glass.
4. Cycle glass to 3/4 down position.
5. With glass fully seated in rear glass guide, bring front glass guide to front edge of glass with finger pressure and tighten attaching fasteners.
Torque: 6 Nm (53 in.lbs.)
6. Install outer door panel.
(Refer to "Outer Panel"Note: Coupe is shown, Sedan and Wagon are similar.:
REMOVAL
1. Remove outer door panel. Outer Door Skin Panel
2. Remove glass. (Refer to "Front Door Glass Replacement")
3. Remove window weatherstrip from guide.
4. Remove foam filler.
5. Remove attaching fasteners and glass guide.
INSTALLATION
1. Install glass guide loosely.
2. Install window weatherstrip.
3. Install glass.
4. Cycle glass to 3/4 down position.
5. With glass fully seated in rear glass guide, bring front glass guide to front edge of glass with finger pressure and tighten attaching fasteners.
Torque: 6 Nm (53 in.lbs.)
6. Install outer door panel.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.