Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1992SL L4-1.9L DOHC VIN 7REPAIR AND DIAGNOSISLIGHTING AND HORNSTESTING AND INSPECTIONHIGH/LOW BEAM HEADLAMPSCOUPE/SC2CIRCUIT TESTINGPOWER CIRCUITSCIRCUIT 11E
1992 Saturn SL L4-1.9L DOHC VIN 7
Circuit 11E
1992 Saturn SL L4-1.9L DOHC VIN 7SECTION Circuit 11E
LOCATION:
Connects I/P cluster connector cavity Q to headlamp switch connector cavity E.
TYPE:
Light Green 22 gage wire
FUNCTION:
This is the ground wire for the high beam telltale in the I/P cluster.
REPAIRS:
Check for OPEN or SHORTS
Repair as needed.
If this component is good, go to the next item indicated on the SYMPTOM CHART.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.