Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSATURN1992SC STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSREMOVAL & INSTALLATION - A/TTORQUE SPECIFICATIONS
1992 Saturn SC Standard
Torque Specifications
1992 Saturn SC StandardSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| Converter Housing-To-Engine (Lower) Bolts | 96 (130) |
| Converter Housing-To-Engine (Upper) Bolts | 74 (100) |
| Cradle-To-Body Bolts | 151 (205) |
| Engine Strut Cradle Bracket-To-Cradle Bolts (1992) | 52 (70) |
| Engine-To-Transaxle Brackets | 35 (48) |
| Exhaust Pipe-To-Catalytic Converter Bolts | 33 (45) |
| Exhaust Pipe-To-Manifold Nuts | 23 (31) |
| Front Transaxle Mount-To-Cradle Nuts (1991) | 35 (48) |
| Front Transaxle Mount-To-Transaxle Bolts (1991) | 35 (48) |
| Lower Ball Joint Nut | 55 (75) |
| Rear Transaxle Mount-To-Transaxle Bolts (1991) | 40 (54) |
| Right Side Transaxle Mount-To-Cradle Nuts (1991) | 40 (54) |
| Steering Gear-To-Cradle Bolts | 40 (54) |
| Tie Rod End Nut | 33 (45) |
| Transaxle Lower Rear Mount-To-Cradle Nut | 40 (54) |
| Transaxle Strut-To-Cradle Bracket Nuts | 52 (70) |
| Transaxle Strut Bracket-To-Cradle Bolts | 52 (70) |
| Wheel Lug Nuts | 103 (140) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.