Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Crankshaft Sensor Pick-Up Coil Short & Resistance Checks
1992 Saturn SC StandardSECTION Crankshaft Sensor Pick-Up Coil Short & Resistance Checks
- Set DVOM on the 2000-ohm scale. Connect leads to crank angle sensor installed in side of engine block. Crankshaft sensor resistance should be 500-900 ohms on all models. If resistance is not as specified, replace sensor.
- With sensor installed in block, connect one ohmmeter lead to either sensor terminal. Touch other ohmmeter lead to engine block. No continuity should exist. If continuity exists, sensor is shorted to ground and must be replaced.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.