SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20109-5REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO SYSTEM WITH NAVIGATIONADJUSTMENT REPLACEMENTRADIO CONTROL MODULE REPLACEMENT
2010 Saab 9-5

Radio Control Module Replacement

2010 Saab 9-5SECTION Radio Control Module Replacement
Fig 1: Identifying Radio Control Module And Fastener
G09435314Courtesy of SAAB-SCANIA OF AMERICA, INC.
Callout Component Name
Preliminary Procedure 
Remove the front floor console cover. Refer to FRONT FLOOR CONSOLE COVER REPLACEMENT .
1 Radio Control Module Fastener
See FASTENER CAUTION .
2 Radio Control Module
Procedure 
  1. Use a flat-bladed plastic trim tool in order to release the retaining clips securing the upper center trim panel to the instrument panel.
  2. Disconnect the electrical connectors.
  3. If replacing Radio Control Module, transfer parts as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.