Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Radio Scan Tool Information
2009 Saab 9-7X 5.3iSECTION Radio Scan Tool Information
Navigation Radio Scan Tool Data Parameters
| Parameter | System State | Expected Value | Description |
|---|---|---|---|
| Operating Conditions: Ignition ON/Engine OFF/Radio ON | |||
| Antenna Enable | __ | Active | The scan tool displays Active/Inactive. |
| CD Changer | __ | Not Connected | The scan tool displays Connected/Not Connected. The scan tool displays Connected when the radio receives Class 2 information from the CD changer. |
| Ign. Cycles Since last DTC | __ | Numeric | The scan tool displays 0-225 Cycles. The number of ignition cycles since a current DTC was set. |
| Personalization Status | __ | Varies | The scan tool displays Unknown, Driver 1, Driver 2. This is the current personalization status. |
| Signal Strength | __ | 51 dB | The scan tool displays the strength of the received signal in dB. |
| Source Status | __ | Varies | The scan tool displays Off/Tuner/Radio Monitor/Cassette/CD/RDS Interrupt/ICDX/CD Changer/Phone Stereo/MD Changer/Single MD/Nav Voice Stereo/Enhanced Stereo/AD Stereo/Phone Mono/Nav Voice Mono/Enhanced mono/AD Mono/RSE Stereo/DRR Tuner. This is the current source/type of the signal being received/played. |
| Theft Armed | __ | Learned VIN | The scan tool displays Learned VIN/No VIN. The Scan tool displays Learned VIN when the theft mode has been turned ON by recognizing a valid VIN. |
| Theft Lock | __ | Unlocked | The scan tool displays Locked/Unlocked. The scan tool displays Unlocked when the radio receives the correct VIN information from the PCM via Class 2. |
Navigation Radio Scan Tool Output Controls
| Output Control | Description |
|---|---|
| Antenna | This control will turn ON and OFF the GPS antenna for the navigation radio. |
| Left Front Speakers | Commanding the speaker ON will turn OFF all speakers except this speaker. Commanding the speaker OFF will turn OFF all speakers. |
| Left Rear Speakers | Commanding the speaker ON will turn OFF all speakers except this speaker. Commanding the speaker OFF will turn OFF all speakers. |
| Right Front Speakers | Commanding the speaker ON will turn OFF all speakers except this speaker. Commanding the speaker OFF will turn OFF all speakers. |
| Right Rear Speakers | Commanding the speaker ON will turn OFF all speakers except this speaker. Commanding the speaker OFF will turn OFF all speakers. |
| Vin Relearn | This commands the navigation radio module to relearn the vehicle vin. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.