Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2009 Saab 9-7X 5.3iSECTION Installation Procedure
- Install the floor shift control. Refer to Transmission Control Replacement .
- Install the console bracket to the vehicle.
- Loosely install all the fasteners that retain the console bracket to the vehicle.
- Install the retaining nuts (1) to the center I/P bracket and tighten to 10 N.m (88 lb in).
- Install the remaining fasteners that retain the console bracket to the vehicle. Tighten the nuts to 25 N.m (18 lb ft).
- Connect the electrical connector to the park brake.
- Connect the electrical connector to the automatic transmission shift interlock solenoid.
- Connect the automatic transmission range selector cable. Refer to Range Selector Lever Cable Replacement .
- Install the center console. Refer to Console Replacement .
- Install the floor shift control knob. Refer to Floor Shift Control Knob Replacement .
- Remove the wheel blocks from the vehicle.
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.