Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSAAB20099-7X 5.3IREPAIR AND DIAGNOSISBODY & FRAMEMIRRORSREPAIR INSTRUCTIONSOUTSIDE REARVIEW MIRROR REPLACEMENTINSTALLATION PROCEDURE

2009 Saab 9-7X 5.3i

Installation Procedure

2009 Saab 9-7X 5.3iSECTION Installation Procedure

Fig 1: Removing/Installing OVRM Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

Install the ORVM assembly to the door. Ensure that the retaining clip is fully seated.

CAUTION: Refer to Fastener Caution .

Install the 3 ORVM retaining bolts and tighten to 10 N.m (88 lb in).

Fig 2: Removing/Installing Side Door Insulator

Courtesy of GENERAL MOTORS CORP.

Install the side door insulator.
Install the ORVM harness to the door.
Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.