Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20099-7X 5.3IREPAIR AND DIAGNOSISBODY & FRAMEFIXED AND MOVEABLE WINDOWSREPAIR INSTRUCTIONSLIFTGATE WINDOW STRUT REPLACEMENTREMOVAL PROCEDURE
2009 Saab 9-7X 5.3i
Removal Procedure
2009 Saab 9-7X 5.3iSECTION Removal Procedure
WARNING:
When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
- Open and support the liftgate window.
- Lift up the retainer clips on the liftgate window struts using a small flat-bladed tool.
- Remove the upper end of the liftgate window struts from the ball joint.
- Remove the lower end of the liftgate window struts from the ball joint.
- Remove the liftgate window struts from the liftgate window.
CAUTION:
When a rear compartment lid hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.