Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Verification
2009 Saab 9-7X 5.3iSECTION Circuit/System Verification
- Ignition ON, observe the operation of the power windows while commanding each window UP and DOWN by using their respective window switches, each window should perform the UP and DOWN function.
- If the driver window is inoperative, refer to Driver Window Malfunction .
- If the front passenger window is inoperative, refer to Passenger Window Malfunction .
- If either rear passenger power window is inoperative, refer to Rear Passenger Window Malfunction .
- Observe the scan tool Driver Window RF Switch, Driver Window LR Switch and Driver Window RR Switch parameters while using the driver master control switches. The parameter should change between Off, Up, Down, Express Down.
- If the parameter does not change, replace the DDS.
- Observe the scan tool Window Lockout parameter while pressing and depressing the window lockout switch on the driver master control. The parameter should change between On and Off.
- If the parameter does not change, replace the DDS.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.