Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2009 Saab 9-7X 5.3iSECTION Installation Procedure
- Position the wiper transmission assembly to the cowl panel plenum.
- Connect the electrical connector to the wiper motor.
- Insert the wiper motor post into the slot in the plenum, push the transmission assembly forward to seat the post.
- Install the bolts retaining the wiper transmission assembly to the vehicle.
Tighten: 10 N.m (89 lb in).
- Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
- Install the windshield wiper arms. Refer to Windshield Wiper Arm Replacement .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.