Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2009 Saab 9-7X 5.3iSECTION Removal Procedure
- Remove the cover from the nut on the wiper arm.
- Hold the wiper arm and remove the nut from the wiper arm.
- Push inward at the wiper arm pivot in order to loosen it from the drive shaft.
- Remove the wiper arm from the pivot shaft.
- Remove the wiper arm blade from the wiper arm. Refer to Windshield Wiper Blade Replacement .
- Clean the knurls of the drive shaft with a wire brush.
NOTE:
Use a battery terminal puller to remove the wiper arm if rocking the wiper arm fails to loosen it from the drive shaft.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.