Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2009 Saab 9-7X 5.3iSECTION Removal Procedure
- Turn the ignition switch to the OFF position.
- Using a plastic flat-bladed tool, carefully remove the bolt cover bezel.
- Fully loosen the two rear retaining bolts. The bolts will remain attached to the video assembly.
- In order to expose the two front retaining bolts, adjust the video display screen to a full open position.
- Fully loosen the front retaining bolts. The bolts will remain attached to the video assembly.
- Close the video display screen.
- Slowly lower the front of the video assembly to release the retaining fastener (3).
- Support the video assembly and disconnect the electrical connector (2).
- Adjust the video assembly in order to release the T-hook (1) from the video player bracket.
- Remove the video assembly from the vehicle.
NOTE:
Do not attempt to service the video display assembly components.
The video display is serviced only as an assembly.
The video display is serviced only as an assembly.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.