SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20099-7X 5.3IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR, ENTERTAINMENT, AND NAVIGATIONREPAIR INSTRUCTIONSDIGITAL RADIO RECEIVER REPLACEMENTREMOVAL PROCEDURE
2009 Saab 9-7X 5.3i

Removal Procedure

2009 Saab 9-7X 5.3iSECTION Removal Procedure
    NOTE: Do NOT swap digital radio receivers between vehicles. Swapping digital receivers between vehicles will activate the digital radio Theftlock®, and "XM Theftlock®" will display.
  1. Lower the right closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
    2. Fig 1: Module Mounting View
    GM1237407Courtesy of GENERAL MOTORS CORP.
  2. Remove the electrical connector (1) from the receiver.
    3. Fig 2: View Of Connector
    GM1237408Courtesy of GENERAL MOTORS CORP.
  3. Remove the antenna electrical connector (1) from the receiver.
    4. Fig 3: Module Mounting View
    GM1236121Courtesy of GENERAL MOTORS CORP.
  4. Remove the nuts retaining the receiver to the insulator panel.
  5. Remove the receiver from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.