SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20099-7X 5.3IREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTCELLULAR, ENTERTAINMENT, AND NAVIGATIONREPAIR INSTRUCTIONSDIGITAL RADIO RECEIVER REPLACEMENTINSTALLATION PROCEDURE
2009 Saab 9-7X 5.3i

Installation Procedure

2009 Saab 9-7X 5.3iSECTION Installation Procedure
    Fig 1: View Of Connector
    GM1237408Courtesy of GENERAL MOTORS CORP.
  1. Position the receiver near the insulator panel.
  2. Install the antenna electrical connector (1) to the receiver.
    3. Fig 2: Module Mounting View
    GM1237407Courtesy of GENERAL MOTORS CORP.
  3. Install the electrical connector (1) to the receiver.
    4. Fig 3: Module Mounting View
    GM1236121Courtesy of GENERAL MOTORS CORP.
  4. Install the receiver to the insulator panel.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the nuts retaining the receiver to the insulator panel and tighten to 5 N.m (44 lb in).
  6. Install the right closeout insulator panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
  7. Perform the setup procedure for the digital radio receiver. Refer to Control Module References .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.