Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2009 Saab 9-7X 5.3iSECTION Installation Procedure
- Install the radio antenna cable assembly to the vehicle.
- Pass the antenna cable and grommet assembly through the fender opening.
- Install the radio antenna cable assembly retaining screws and tighten to 2.8 N.m (25 lb in).
- Close the hood.
- Install the antenna mast. Refer to Fixed Antenna Mast Replacement .
- Reach up behind the wheelhouse panel and pass the end of the radio antenna cable assembly through the cowl opening (1).
- Install the antenna cable grommet assembly to the cowl opening.
- Install the wheelhouse panel. Refer to Wheelhouse Panel Replacement (Rear End) or Wheelhouse Panel Replacement (Front End) .
- Install the radio antenna cable (2) to the radio extension cable.
- Close the I/P compartment.
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.