SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20099-7X 5.3IREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEM WITH TCS & VSESREPAIR INSTRUCTIONSWHEEL SPEED SENSOR REPLACEMENTREMOVAL PROCEDURE
2009 Saab 9-7X 5.3i

Removal Procedure

2009 Saab 9-7X 5.3iSECTION Removal Procedure
    Fig 1: Brake Rotor Removed From Hub
    GM748559Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Remove the brake rotor. Refer to Front Brake Rotor Replacement .
    4. Fig 2: Identifying Wheel Speed Sensor Wiring Harness
    GM886518Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel speed sensor wiring harness retainers.
    5. Fig 3: Locating Connector
    GM886517Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the wheel speed sensor electrical connector.
    6. Fig 4: Removing/Installing Sensor Mounting Screw
    GM777335Courtesy of GENERAL MOTORS CORP.
  6. Remove the wheel speed sensor bolt.
    7. Fig 5: Removing/Installing Speed Sensor
    GM748580Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.