SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20099-7X 5.3IREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLANTILOCK BRAKE SYSTEM WITH TCS & VSESREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE REPLACEMENT
2009 Saab 9-7X 5.3i

Electronic Brake Control Module Replacement

2009 Saab 9-7X 5.3iSECTION Electronic Brake Control Module Replacement
Fig 1: Identifying Electronic Brake Control Module Components
GM1706930Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Refer to Fastener Caution .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .Preliminary Procedure: Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
1 Electronic Brake Control Modulator (EBCM) Electrical Connector
Tip:  Clean the dirt and debris from around the EBCM before disconnecting the electrical connector.
2 Screw (Qty: 4)

Tighten:  3 N.m (26 lb in)
3 Electronic Brake Control Modulator (EBCM)
Tip: 
  1. A slight amount of force may be necessary to separate the EBCM from the brake pressure modulator valve (BPMV). DO NOT pry on the EBCM.
  2. After separating the EBCM from the BPMV, cover the BPMV with a lint-free towel to prevent it from becoming contaminated.
  3. Care should be used when installing the EBCM to the BPMV to avoid damage to the internal components.
  4. Program the EBCM. Refer to Control Module References for programming and setup information.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.