Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Installation Procedure
2009 Saab 9-7X 5.3iSECTION Installation Procedure
- Install the seat back. Refer to Front Seat Back Replacement .
- Install the 4 nuts that secure the seat pan to the power seat adjuster frame and tighten to 25 N.m (18 lb ft).
- Install the SIR harness (2) to the seat clips (1,4).
- Connect the gray lumbar electrical connector (5), if equipped.
- Connect the black electrical connector (3) to the seat belt buckle.
- Connect the black electrical connector (6) to the seat back harness.
- Install the seat belt buckle to the seat with the nut and tighten to 55 N.m (41 lb ft).
- Install the seat cushion trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
- Install the front bucket seat assembly to the vehicle. Refer to Front Seat Replacement - Bucket .
- If the vehicle is equipped with memory seats, calibrate the seat. Refer to Memory Seat Calibration .
CAUTION:
Refer to Fastener Caution
.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.