SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20099-3 2.0T, 4D WAGON, FWD, STANDARDREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSDOORS & LOCKSREPAIR INSTRUCTIONSBOOT LID LOCKTO REMOVE
2009 Saab 9-3 2.0T, 4D Wagon, FWD, Standard

To remove

2009 Saab 9-3 2.0T, 4D Wagon, FWD, StandardSECTION To remove
  1. Open the boot lid and remove the Boot lid trim. See BOOT LID TRIM .
    Fig 1: Illustration For Steps 1-2
    G05064125Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. US/CA:  Loosen the cable from the emergency opening handle.
  3. Remove the cover from the lock by inserting a screwdriver and undoing the clips.
    Fig 2: Removing Cover From Lock
    G05064126Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Certain cars: Remove the cover bolt.

    Remove the lock's screws

    Fig 3: Illustration For Steps 4-5
    G05064127Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Part the connector.
  6. US/CA:  Remove the emergency opening cable from the bracket.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.