Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20059-3 LINEAR (9440) L4-2.0L TURBO (2.0T)REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW CONTROL MODULESERVICE AND REPAIRDOOR CONTROL MODULE, CV (702D/P)
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)
Door Control Module, CV (702D/P)
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)SECTION Door Control Module, CV (702D/P)
Door Control Module, CV (702D/P)
To remove
1. Perform the procedure for Before removing a control module
2. Remove Door trim, CV.
3. Lay the side of the door on a clean, soft surface.
4. Unplug the connector for the luggage compartment switch.
5. When replacing the driver's door module: Remove the door trim bolt.
6. Remove the control module with a screwdriver. First, remove the rear clip followed by the internal and external door module clips. Carefully pull the control module downwards and to the rear.
To fit
1. Fit the control module at an upward angle so the clips engage.
2. When replacing the passenger door module: Remove the door trim bolt.
3. Plug in the connector for the bootlid switch.
4. Fit the door trim.
5. Cars with pinch protection: Perform Programming of the pinch protection.
6. Perform the procedure for After fitting a control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.