Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20059-3 LINEAR (9440) L4-2.0L TURBO (2.0T)REPAIR AND DIAGNOSISWINDOWS AND GLASSWINDOWSPOWER WINDOW CONTROL MODULEDESCRIPTION AND OPERATIONCONTROL MODULE, REAR RIGHT WINDOW LIFT, CV (702RR)
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)
Control Module, Rear Right Window Lift, CV (702RR)
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)SECTION Control Module, Rear Right Window Lift, CV (702RR)
Control Module, Rear Right Window Lift, CV (702RR)
Location
Main task
The primary function of the RRDM is to control and supply the rear right-hand window lift (with optional pinch Protection function).
The RRDM also has logic for the door mirror heater. The activation command is transmitted on the bus.
Type
Internally there is a microprocessor with clock, RAM and a flash EPROM. An internal bus which connects the processor and memory with the I/O unit. The I/O unit is responsible for reading in the values of A/D converted analogue inputs, digital inputs, bus signals and for activating transistors in the output amplifier.
For further information about the control module see control module, general description.
Power supply, ground and bus communication
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.