Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20059-3 LINEAR (9440) L4-2.0L TURBO (2.0T)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTGLOBAL POSITIONING SYSTEMSERVICE AND REPAIRTELEMATICS UNIT (468)CONVERTIBLE
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)
Convertible
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)SECTION Convertible
Telematics Unit (468), CV
To remove
1. Carry out procedures before removing a control module.
2. Remove the front luggage compartment trim.
3. Remove the two bracket bolts.
IMPORTANT: Take care when releasing the locking mechanism on the connector so as not to damage the connector. Pull the halves straight apart to avoid bending the pins. For further information regarding connectors, refer to Connectors, handling and inspection.
4. Unplug the connectors.
5. Remove the telematics unit with bracket.
6. Remove the bracket by pressing out the telematics unit.
To fit
1. Fit the bracket to the telematics unit.
2. Place the telematics unit in fitting position.
IMPORTANT: Take care when plugging in the connector so as not to damage or press out the pins/sleeves in the connector. For further information regarding connectors, refer to Connectors, handling and inspection.
3. Plug in the connector.
4. Fit the two bracket bolts.
5. Fit the front luggage compartment trim.
6. Carry out procedures after changing a control module.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.