Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20059-3 LINEAR (9440) L4-2.0L TURBO (2.0T)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSSERVICE AND REPAIRANTI-THEFT ALARM SENSOR (690)SEDAN
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)
Sedan
2005 Saab 9-3 Linear (9440) L4-2.0L Turbo (2.0t)SECTION Sedan
Anti-Theft Alarm Sensor (690), 4D
To remove
1. Remove the lens protector from the dome light.
2. Remove the switch panel cover.
3. Remove the theft alarm sensor by pressing a screwdriver against the clips.
4. Unplug the connector.
To fit
1. Plug in the connector.
2. Fit the theft alarm sensor. A click should be heard.
3. Fit the switch panel cover.
4. Fit the lens protector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.