2004 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE

Main components

Fig 1: Identifying ABS 5.4 System Main Components
G03744553Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Hydraulic unit, complete with control module, valve block and return pump (547)
  2. ABS warning lamp on MIU (540)
  3. Wheel sensor, FR (298)
  4. Wheel sensor, FL (298)
  5. Wheel sensor, RR (298)
  6. Wheel sensor. RL (298)
  7. Page 1 of 1 In
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.