2004 Saab 9-5 Linear, AutomaticFACTORY OEM SERVICE PROCEDURE

ABS modulation: Notes

Fig 1: Identifying ABS Modulation Graph
G03744576Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Speed
  2. Braking force
  3. Road speed
  4. Wheel speed (of rotation)
  5. Inlet valve open, outlet valve closed
  6. Inlet valve closed, outlet valve closed
  7. Outlet valve open, return pump actuated

When the control module detects that the retardation of a wheel is too high (increase in wheel speed), it modulates the brake pressure in three phases.

Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.