Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB20039-3 CONVERTIBLE (9400) L4-2.0L TURBO (2.0 HOT)REPAIR AND DIAGNOSISACCESSORIES AND OPTIONAL EQUIPMENTANTITHEFT AND ALARM SYSTEMSSERVICE AND REPAIRRECEIVER FOR REMOTE CONTROL
2003 Saab 9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT)
Receiver For Remote Control
2003 Saab 9-3 Convertible (9400) L4-2.0L Turbo (2.0 HOT)SECTION Receiver For Remote Control
Receiver For Remote Control
To remove
1. Remove the cover and unscrew the screw holding the rear section of the floor console.
2. Lift off the rear section.
3. Undo the receiver unit from the side wall of the floor console.
4. Unplug the connector and remove the receiver unit.
To fit
1. Fit the connector to the receiver.
2. Fit the receiver unit.
3. Fit the rear section of the floor console.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.