Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19959000 CS, AUTOMATICREPAIR AND DIAGNOSISELECTRICALCOMPONENT LOCATIONSELECTRICAL COMPONENT LOCATORCONNECTORS
1995 Saab 9000 CS, Automatic
Electrical Component Locator: Connectors
1995 Saab 9000 CS, AutomaticSECTION Connectors
CONNECTORS
| Component | Component Location |
|---|---|
| H2-15 (2-Pin) | In right "A" pillar. |
| H2-33 (2-Pin) | In left "A" pillar. |
| H2-62 (2-Pin) | In left side of tailgate. |
| H2-67 (2-Pin) | In right side of tailgate. |
| H2-78 (2-Pin) | Behind glove box. |
| H3-10 (3-Pin) | On electronics bracket, under left seat. |
| H3-11 (93-Pin) | On electronics bracket, under right seat. |
| H4-12 (4-Pin) | Near right front wheelwell. |
| H4-15 (4-Pin) | Under left side of right seat. |
| H4-21 (4-Pin) | Near generator. |
| H6-4 (6-Pin) | In tailgate, near rear window. |
| H6-5 (6-Pin) | Right front of engine compartment, near washer fluid reservoir. |
| H6-6 (6-Pin) | Right of rear window wiper. |
| H8-3 (8-Pin) | Under driver seat. |
| H8-4 (8-Pin) | Near left rear wheelwell. |
| H10-4 (10-Pin) | Behind glove box, on heater housing servo motor bracket. |
| H10-5 (Green, 10-Pin) | Under left seat. |
| H10-6 (10-Pin) | Near left rear wheelwell. |
| H10-11 (10-Pin) | Left side of dash, behind knee shield. |
| H10-14 (10-Pin) | In left side of luggage compartment, near bulb monitor. |
| H10-15 (10-Pin) | Behind left headlamp. |
| H10-22 (10-Pin) | In right "B" pillar. |
| H10-24 (10-Pin) | In left "B" pillar. |
| H10-25 (10-Pin) | Behind left headlamp. |
| H16-1 (16-Pin) | Below steering wheel. |
| H22-1 (22-Pin) | Behind cable entry, on left "A" pillar. |
| H22-2 (22-Pin) | Behind cable entry, on right "A" pillar. |
| H70-1 (70-Pin) | In engine compartment, behind firewall. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.