Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19959000 CS, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSSERVICING - A/TADJUSTMENTSTHROTTLE VALVE (TV) CABLE9000 SERIES
1995 Saab 9000 CS, Automatic
9000 Series
1995 Saab 9000 CS, AutomaticSECTION 9000 Series
- Measure distance between cable crimp and cable housing when throttle is opened to wide open position (just before kickdown on transmission cam). Distance should be 1.54" (39 mm).
- With throttle in idle position, again measure distance between cable crimp and cable housing. Distance should be .098" (2.5 mm). Loosen both lock nuts on throttle housing bracket to adjust. Tighten lock nuts.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.