Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Knock Sensor (KS)
1995 Saab 9000 CS, AutomaticSECTION Knock Sensor (KS)
- Connect timing light. With engine running at a fast idle, tap cylinder head with a plastic mallet. If timing retards, knock sensor is okay. If timing does not retard, turn ignition switch off and go to next step.
- Locate knock sensor under intake manifold. Unplug connectors from sensor and ignition ECM. Inspect wiring between knock sensor and ECM connector. See the WIRING DIAGRAMS - 2.3L TURBO article. If open or short circuit is located, repair as necessary. Reconnect knock sensor and ECM, and retest system. If wiring is good, go to next step.
- Temporarily replace knock sensor with known good unit. Repeat step 1). If timing still does not retard, reinstall original sensor and replace ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.