SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB1995900 S, 2D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (ANTI-LOCK BRAKE SYSTEM)TROUBLE SHOOTINGANTI-LOCK WARNING LIGHTABS WARNING LIGHT INOPERATIVE
1995 Saab 900 S, 2D Hatchback, Automatic

ABS Warning Light Inoperative

1995 Saab 900 S, 2D Hatchback, AutomaticSECTION ABS Warning Light Inoperative
WARNING: This page is about a different car, the 1996 Saab 900. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect ABS ECM connector. Turn ignition on. Connect jumper wire between ABS ECM connector terminals No. 19 and 21. See Figure . If ABS light does not come on, go to next step. If ABS light comes on, check ABS ECM connector terminals for dampness, corrosion, or looseness. Repair as necessary. If ABS light still does not operate, replace ABS ECM.
  2. Check for an open circuit in Gray/Green wire between ABS ECM terminal No. 21 and instrument cluster connector terminal No. 16. Repair as necessary. If circuit is okay, replace instrument cluster. If ABS light is still inoperative, replace ABS ECM.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.