SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19949000 CD, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)GENERAL INFORMATIONRESTRAINTSAIR BAG DEACTIVATION PROCEDURESFORD MOTOR CO.DISABLING & ACTIVATING AIR BAG SYSTEMDISABLING SYSTEM
1994 Saab 9000 CD, Standard

Disabling System

1994 Saab 9000 CD, StandardSECTION Disabling System
WARNING: Disabling procedure should be used for component replacement purposes only. If vehicle was involved in a collision and air bag did not deploy or if SRS is not functioning properly, and if vehicle needs to be driven, complete system deactivation is required. For information on COMPLETE SYSTEM DEACTIVATION, see appropriate AIR BAG RESTRAINT SYSTEM article in RESTRAINTS.

Disconnect negative and then positive battery cables. Shield both cables. SRS contains a back-up power supply built into air bag diagnostic monitor. Wait at least one minute before servicing any air bag components. System is now disabled. To activate SRS, see ACTIVATING SYSTEM .

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.