Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19949000 AERO, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSOVERHAUL - ZF 4HP 18ON-VEHICLE SERVICEAXLE SHAFTSASSEMBLY & INSTALLATION (LEFT SIDE)
1994 Saab 9000 Aero, Standard
Assembly & Installation (Left Side)
1994 Saab 9000 Aero, StandardSECTION Assembly & Installation (Left Side)
Press new bearing assembly into housing and install seal. Install axle shaft and snap ring. Install "O" ring, spring and tappet. See Figure. Start shaft into housing and install 5 bolts. Tighten bolts to 17 ft. lbs. (23 N.m).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.