Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19949000 AERO, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSOVERHAUL - ZF 4HP 18ON-VEHICLE SERVICEGOVERNORGOVERNOR REASSEMBLY
1994 Saab 9000 Aero, Automatic
Governor Reassembly
1994 Saab 9000 Aero, AutomaticSECTION Governor Reassembly
- Install new oil seals in governor support. Seal position is important. Install small diameter seal with seal lip toward the rear of governor support.
- Install large diameter seal with seal lip facing out. Install new "O" rings on governor support. Lubricate with petroleum jelly. Install governor valves on governor body and tighten bolts to 89 INCH lbs. (10 N.m).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.