Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB1994900 SE, 4D HATCHBACK, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEDOOR LOCKSANTI-THEFT SYSTEMTROUBLE SHOOTINGLED ALARM SETTINGS
1994 Saab 900 SE, 4D Hatchback, Automatic
Led Alarm Settings
1994 Saab 900 SE, 4D Hatchback, AutomaticSECTION Led Alarm Settings
- LED in center of dash will flash to provide information about status of alarm system. A steady light indicates a 10-second arming delay is in progress. An LED flashing at 2-second intervals after 10-second delay indicates system is armed.
- An LED flashing at one second intervals during 10-second delay period after system is armed indicates a door is open or system has detected a fault. If all doors, hood and luggage compartment are closed but LED flashes during 10-second delay after arming, a fault may be present in theft alarm system.
LED FLASH PATTERN
| Condition | Flashes |
|---|---|
| 0 (Non-Energized) | Off |
| 1 (Non-Activated) | Off |
| 2 (Activated) | Flash |
| 3 (Alarm Set Off) | 2 Flashes Per Second |
| 5 (Disconnected, Transport Mode) | 1 Flash Per 4 Seconds |
| 7 (Programming Mode) | 1 Flash Per 2 Seconds |
| 8 (Sensitivity Test) | 2 Flashes Per Second |
| 9 (Diagnostic Mode) | Steady Light |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.