Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Seats - Power: Operation
ECU supplies motors, position sensors, and switches with voltage. ECU monitors switches, and when a determined combination of switches have been activated, it performs the appropriate operation. If a seat motor is operating, ECU monitors its voltage consumption and position of seat as determined by position sensors. ECU can store seat settings and fault codes.
With ignition switch in ON position, left seat switch is supplied with voltage from fuse No. 16. Right seat switch is supplied with voltage from fuse No. 5. On memory power seat, voltage is supplied from fuse No. 16.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.