Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB1994900 S, 2D CONVERTIBLE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - SYSTEM/COMPONENT TESTSCOMPUTERIZED ENGINE CONTROLSELECTRONIC CONTROL MODULE (ECM) (900 SERIES WITH TRIONIC IGNITION)POWER CIRCUIT
1994 Saab 900 S, 2D Convertible, Standard
Power Circuit
1994 Saab 900 S, 2D Convertible, StandardSECTION Power Circuit
- Check for battery voltage at terminals No. 1 (Pink/White wire) and 48 (Pink/White wire). If battery voltage does not exist, repair Red wires between ECM and fuse panel.
- Turn ignition on. Check for battery voltage between ECM terminal No. 60 (Yellow/Gray wire) and ground. If battery voltage does not exist, repair open in Yellow/Gray wire.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.