SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB1994900 COMMEMORATIVEREPAIR AND DIAGNOSIS (SINGLE PAGE)RESTRAINTSAIR BAG, SRSAIR BAG RESTRAINT SYSTEMREMOVAL & INSTALLATIONSTEERING WHEELINSTALLATION
1994 Saab 900 Commemorative

Steering Wheel: Installation

1994 Saab 900 CommemorativeSECTION Installation
  1. To ensure clockspring is centered, set front wheels to straight-ahead position. Rotate clockspring clockwise until it stops, and then rotate counterclockwise 2 1/2 turns. Maintain clockspring in this position.
  2. Thread air bag module and horn wiring harnesses through hole in steering wheel. Slide steering wheel onto shaft. Align match marks on shaft and steering wheel. Align clockspring with hole in wheel.
  3. Install steering wheel nut, and tighten to specification. See TORQUE SPECIFICATIONS  at the end of this article. Connect air bag module and horn pad electrical connectors. Install air bag module. Install screws on back of steering wheel.
  4. Reactivate SRS. See DISABLING & ACTIVATING AIR BAG SYSTEM  . Check air bag warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK  .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.