Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Instrument Panel: Testing: Speedometer
Ensure fuses No. 17 and 18 are okay. Raise and support vehicle. Turn ignition on. Rotate wheels by hand. ABS control module should send a pulsed A/C speed signal to terminal No. 7 (Gray/Green wire) of main instrument display No. 1, and terminal No. 5 (Orange/White wire) of main instrument display No. 2. If pulsed signal is not present, check for an open or short circuit.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.