Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19939000 CD, 2.3 B, STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - SYSTEM/COMPONENT TESTSIGNITION SYSTEMTIMING CONTROL SYSTEMSKNOCK SENSOR (EXCEPT 9000 SERIES TURBO)
1993 Saab 9000 CD, 2.3 B, Standard
Knock Sensor (Except 9000 Series Turbo)
1993 Saab 9000 CD, 2.3 B, StandardSECTION Knock Sensor (Except 9000 Series Turbo)
- Connect timing light. With engine running at a fast idle, tap cylinder head with a plastic mallet. If timing retards, knock sensor is okay. If timing does not retard, turn ignition switch off. Go to step 2) for 900 Series, or to step 4) for 9000 Series.
- On 900 Series, locate knock sensor under intake manifold. Unplug connectors from sensor and ignition ECM. Check Green wire for continuity between harness connector and ignition ECM pin No. 13. Also check Green wire for short to ground, to Brown wire, or to shield.
- Check Brown wire for continuity between harness connector and ignition ECM pin No. 12. Also check Brown wire for short to ground, to Green wire, or to shield. Ensure there is continuity between shield and ground. Replace wire assembly if defective. Go to step 6).
- On 9000 Series, locate knock sensor under intake manifold. Unplug connectors from sensor and ignition ECM. Check Gray wire for continuity between harness connector and ignition ECM pin No. 11. Also check Gray wire for short to shield or to ground.
- Check shield for continuity between sensor harness connector and ignition ECM pin No. 30. Check shield for short to ground. Replace wire if defective.
- Temporarily replace knock sensor with known good unit. Repeat step 1). If timing still does not retard, reinstall original sensor and replace ignition ECM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.