Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19939000 CD, 2.3 B, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - TESTS W/CODESFAULT CODES (WITHOUT USING ISAT SCAN TESTER)ERROR CODE 12225
1993 Saab 9000 CD, 2.3 B, Standard
Error Code 12225
1993 Saab 9000 CD, 2.3 B, StandardSECTION Error Code 12225
- The check engine light is on. Oxygen sensor output is incorrect. Sensor pre-heater circuit may be open. Engine temperature must be above 158°F.
- Check oxygen sensor output voltage (voltage fluctuating between 0 and 1.0 volt). Check oxygen sensor pre-heater circuit and fuse.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.