Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19939000 CD, 2.3 B, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCESYSTEMENGINE CONTROLS - BASIC TESTINGIGNITION CHECKSDIS IGNITION SYSTEM (9000 SERIES NON-TURBO))QUICK CHECK
1993 Saab 9000 CD, 2.3 B, Standard
Quick Check
1993 Saab 9000 CD, 2.3 B, StandardSECTION Quick Check
- Check fuse No. 9 in fuse block (ignition power feed). Measure voltage at Red wire going into ignition cartridge. With ignition on, battery voltage should exist.
- Turn ignition off. Remove fuse No. 14 (fuel pump). Remove ignition cartridge and spark plugs. Install spark plugs into ignition cartridge. Using jumper wires, connect negative electrodes of spark plugs together. Ground other ends of jumper wires.
- With ignition key, crank engine and observe tachometer. Needle of tachometer should hunt. Verify spark exists at all spark plugs. Release ignition key to RUN position for about 5 seconds. Verify tachometer needle hunts and multiple sparks occur at all spark plugs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.