Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB1993900 L4-2118CC 2.1L DOHCREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSSERVICE PRECAUTIONSVEHICLE DAMAGE WARNINGSPROPER TOOLS AND TESTING PROCEDURES
1993 Saab 900 L4-2118cc 2.1L DOHC
Proper Tools and Testing Procedures
1993 Saab 900 L4-2118cc 2.1L DOHCSECTION Proper Tools and Testing Procedures
WHEN TESTING A CONTROL UNIT OR RELATED ELECTRONIC COMPONENTS;
To obtain accurate measurements and to avoid damaging low voltage circuits and components, use a Digital Volt-Ohm Meter (DVOM) with a minimum 10 mega-ohms internal impedance (unless use of an analog meter is specified by a test procedure).
Analog meters have lower internal impedance and will "load" low voltage circuits, resulting in inaccurate measurements and possible damage to circuits and components.
TEST PROCEDURES
Always follow recommended testing procedures;
^ Never ground or apply voltage to a circuit unless specified by a testing procedure.
^ The control unit provides some circuits with a regulated, constant, low voltage source which may require a minimum resistance (impedance) to operate.
^ Directly grounding or applying battery power to these circuits could damage the control unit, causing system failure.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.