Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB1990900 SPG, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSELECTRICAL COMPONENT LOCATIONSDIAGNOSTIC CONNECTOR (DLC) LOCATIONSIMPORTED CARS & TRUCKSLAND ROVER
1990 Saab 900 SPG, Standard
Land Rover
1990 Saab 900 SPG, StandardSECTION Land Rover
NOTE:
This table provides a quick reference for self-diagnostic connector locations, when available from manufacturer, that ARE NOT
located at the lower left side of the dash, as mandated in 1996 by the Federal government.
LAND ROVER - IMPORTED CARS & TRUCKS
| Application | Connector Location |
|---|---|
| Defender 90 | Behind Fuse Cover, In Center Of Console |
| Range Rover | Under Right Side Of Dash, In Footwell |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.