Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSAAB19879000 L4-1985CC 2.0L DOHCREPAIR AND DIAGNOSISHEATING AND AIR CONDITIONINGCONTROL MODULE HVACSERVICE AND REPAIRACC CONTROL MODULE, CHANGING
1987 Saab 9000 L4-1985cc 2.0L DOHC
ACC Control Module, Changing
1987 Saab 9000 L4-1985cc 2.0L DOHCSECTION ACC Control Module, Changing
Removal:
1. Switch off the ignition.
2. Remove the ashtray.
3. Pull the ashtray holder forward by bending down the two upper locking tabs.
4. Press out the control module from behind.
5. Unplug the 25 pin connector.
Installation
1. Plug in the connector.
2. Place the control module in position.
3. Clip in the ashtray holder and the ashtray.
4. Carry out user programming as required by the customer.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.